phoenix
phoenixPhoenix - Your AI Assistant
Inactive session will be ended in 24 hours
End Session

RTA001674-PWR

  • Posted:
  • Proposals: 13
  • Remote
  • #4389357
  • OPPORTUNITY
  • Expired
Abdulgafar H.Daniel B.Sohaib A.Wasantha G.Infodart T. + 8 others have already sent a proposal.
  • 3

Description

Experience Level: Expert
I need some one can build the hex files for I to control 2 IN’s and 2 OUT’s with pic micrcontroller in sot 14 pins

New Proposal

Login to your account and send a proposal now to get this project.

Log in

Clarification Board Ask a Question

  • Wasantha G.

    Should OUT2 generate exactly 3 pulses of 500ms each after 5 minutes every time OUT1 goes high, or only the first time?

    Do you need any specific protection features like watchdog timer or reset behavior?

    Are there any low-power or sleep mode requirements for the firmware?

    Do you require source code delivery, or just the compiled HEX file?

    Timothee T.11 Jun 2025

    Just hex file

  • Wasantha G.

    What is the supply voltage for the PIC (e.g., 5V or 3.3V)?

    Timothee T.11 Jun 2025

    5VOLTS

  • Wasantha G.

    Should I use the internal 4.096V voltage reference for comparing IN1 and IN2?

    Timothee T.11 Jun 2025

    Yes use internal volts for comparison

  • Wasantha G.

    What is the exact pin assignment for CTRL1, CTRL2, IN1, IN2, OUT1, and OUT2 on the PIC16F1574?

    Timothee T.11 Jun 2025

    In figure 1 there are all about pin assignation, but that can be changed by you if not compatible, pin2= ctrl1, pin3=ctrl2, pin6=out1, pin7=out, pin10=in1, pin13=in2

  • Wasantha G.

    Is the PIC configured to use an internal oscillator (e.g., 4 MHz), or is an external clock used?

    Timothee T.11 Jun 2025

    Pic use internal oscillator