URGENT revision of CAD drawing needed done within the next 2 hours
- or -
Post a project like this- Posted:
- Proposals: 12
- Remote
- #2311911
- Awarded
Description
I have a layout of a bingo hall done but need it done in CAD. I have a current CAD copy but the file is a pdf and measurements need adjusting, I've just attached it to show a quick CAD overview of the previous layout. This can be copied with the new measurements. I attached screenshots of the spreadsheet incase easier to read.
Please work off the spreadsheet layout for the amended version
Notes -
1. There must be 1200mm gap between the seating
2.measurements of seating and tables is detailed on spreadsheet and needs to match
3. For tables of 6, the divide line with tables needs to be between the set of 4 to a table and set of 2 to a table (current CAD daring the divide line goes through the middle of a table of 6)
4. The green walls are divider walls are stud walls 120mm width
Please only reply if you are trained in CAD.
Danielle F.
100% (6)New Proposal
Login to your account and send a proposal now to get this project.
Log inClarification Board Ask a Question
-
The disabled toilet shown on the PDF does not conform to the building regulations, with door opening inwards. Are we to allow to adjust, or to copy direct as shown.
Danielle F.21 Feb 2019The door is to open outwards, I just highlighted where the door was to go on the spreadsheet with colour and I couldnt do a line of colour so just highlighted the box either above or below where the doors are to go.
-
Do you require the furniture drawn like in first drawing, or second where it is just areas marked out ?
Can you confirm handing of building, as PDF has toilets to the right, and spreadsheet has toilets to the left … will affect where drainage goes and would need to know if it is just adjusting dimensions as you say, or re-draw as it appears.Danielle F.21 Feb 2019Furniture to be the same as the previous pdf CAD version - the spreadsheet is showing the updated measurements and layout. The CAD shows the entrance for toilets throughout the machines area. I have since amended this (excel document) to have them separate.
-
Did you just go for the cheapest?
Danielle F.21 Feb 2019No I didn't. I went with someone I thought was from Canada at my fixed rate, not cheaper who I believed had the skills to do it in CAD. I was wrong. They did do it in revit which can be converted to CAD but it's too different than the original. They were also a cert 5.