Code and Program Arduino or Raspberry Pi for an Escape Room game

  • Posted:
  • Proposals: 7
  • Remote
  • #1976510
  • Open for Proposals
Sebastián M.Yasha K.Metin A.Gaurav S.Swarna R. + 2 others have already sent a proposal.
  • 14

Description

Experience Level: Intermediate
Basically trying to replicate the following: https://www.youtube.com/watch?v=oBY7m4yPe9I ....although when I saw it in person there were ways to cheat and also it glitched a few times. It could be run off a raspberry pi or an arduino. So a person is placed in room and they have to figure out the puzzles and never let go of the red button on the seat. The room is lit with WRGB LED strips and I would like an idle mode of the white leds dimmed and have a image displayed on the flatscreen TV mounted inside room. Person sits on the red button on the chair which led strip lights change to slow flashing red and plays an mp3 file of the rules and displays them on TV, also in the mp3 it says you have to escape with an audience and I would like a relay to activate to turn on audience lights. After mp3 is complete, I have two rows of 6 pixel led strips, which will display a color combination out of red and green, the person has to flip 12 breakers in an electrical panel, one way represents red the other green and they have to match the led combination. I would like 5 different combinations that would cycle through after each game so the next customers cant memorize the pattern. Also when the rules mp3 finishes, I need the TV to display a countdown timer M:S:MS of 2 and half minutes, also the LED lights in the room can cycle through RGB all this as the same time the breaker game displays a combination. So when they match the color combo I would like a relay to close (if they change the breakers relay will open again), that relay is going to activate a 12v green light and activate a latch to disengage for a box containing 3 colored XLR cords, the person has to match the the cords to colored inputs around the room, I'm just having it wired in series so once cords are plugged in it completes a 12v circuit and deenergizes a magnet that allows a key to fall down. the person then has to turn the key into a key switch and game will end as a win as long as they completed under the time limit and never let go of the button. For a win, I would like the breaker game to turn off, also the audience light relay, white led room lights strobe, tv displays a winner image and plays an mp3. After mp3, room lights turn solid white then system goes back to idle mode only after a game reset button has been pressed. For a fail scenario, whether someone lets go of the red button or runs out of time, the breaker game turns off, room lights strobe red, audience light relay turns off, another relay closes for 10 seconds to activate a fog machine, TV flashes the time (if button was let go) for 5 seconds then displays FAIL, also mp3 plays. After mp3, same as win scenario, lights go to white then system idle after reset button is pressed. That's basically it man, I think this should be no problem for you. You got 15 inputs (Red Button, Reset Button, 12 breaker game and the ending key) and I need 3 no/nc relays outputs, HDMI out for TV and how ever you want to control the room light and breaker game strips. System needs to be standalone without internet access. Also would like inputs to be "triggered" by 12vdc.

New Proposal

Create an account now and send a proposal now to get this job.

Sign up

Clarification Board Ask a Question

    There are no clarification messages.