Building Plot Layout

  • Posted
  • Proposals 11
  • Remote
  • #12759
  • Archived
Razmik H.Chris A.Roger H.Nesh P.Mmm B. + 6 others have already sent a proposal.
  • 2

Description

Experience Level: Expert
Hello
I have a \'full planning submission pack\' for a 4 bed house which was submitted for one particular plot.

I now want to know if this desgn will fit on another plot.

I have done a rough & dirty measure-up on site and also using Promap and I consider that the design will fit etc. I have (in the past) done my own layout plans etc, but so I can get on with other tasks, I am posting on here.

It is a triangular plot covered in 4 ft high brambles and surrounded by 6 ft wide conifer hedges ... not the best scenario for accurate measurements ... hence the rough and dirty measure-up.

I would propose that you use the boundaries / plot size as shown on Promap and overlay the footprint of the 4 bed design etc. If the layout gets \'critical\' at some point then I can do on-site measurements as / where required.

This first task would likely lead into pulling together a \'full planning pack\' (using the design / plans I already have) and then later doing a building regs submission etc.

I hope above makes sense and I have provided sufficient information for you to bid, but if you have any questions or require further information please ask away.

Thanks
Graham

New Proposal

Create an account now and send a proposal now to get this job.

Sign up

Clarification Board

    There are no clarification messages.