
Insights
Insights
by Charlie J.
- Posted: 25 Jan 2016
by Thomas P.
- Posted: 11 Jan 2016
-
Thomas P.
San Francisco, CA, USCraig did everything that I asked for, which is why I'm giving him a 4 star rating of very good, but didn't go out of his way at all to suggest potential improvements. For example, when I later took this file to my 3D printer, he said that the edges were very sharp and that they had a tendency to chip up when 3D printed, and suggested the work be amended to have rounder edges. Since this was my first go at making a CAD file for a prototype, this is information that would have been the difference of just adequately performing the task set forth, and going above and beyond and deserving 5 stars.
It felt like he did the task very fast, and a couple of times I had to look at the file he sent me and remind him of some design features that he had omitted but that were in the drawing and that he should have spotted quite easily if he paid enough attention.
In summary, job well done because the file itself was good and useful, but in order to receive 5 stars he would have had to spend the extra minute or so it would have taken to get the design right the first time, and make minor recommendations based on his experience being very good at making CAD drawings.
by Kate L.
- Posted: 23 Nov 2015

by Eloise P.
- Posted: 16 Sep 2015
by Robert J.
- Posted: 8 Sep 2015
by Mark C.
- Posted: 8 Sep 2014
by Andrew A.
- Posted: 29 Oct 2014
I need 2D Roofing detail drawings converting from our hand sketches to CAD
by Paul M.
- Posted: 14 Jul 2014