Create and configure two networks using Cisco Packet Tracer

Using Cisco Packet Tracer and the table and diagram below, create and configure the networks listed below. You will need to configure the routers with the Routing Information Protocol (RIP) to allow traffic to traverse the networks.

Make sure you create a label that contains your name.

Once you have configured the networks based on the table and diagram provided and have setup RIP, open a command prompt on PC1 and verify that traffic flows between the networks by successfully pinging PC0.

I can give you access to my account to do this.
Device Configuration
Location Device IP Address
Location A
PC0 192.168.0.50 /24
Server0 192.168.0.100 /24
Switch0 N/A
Router0 (Inside Address) 192.168.0.1 /24
Router0 (Serial) 67.15.0.1 /30
Location B
Router1 (Serial) 67.15.0.2 /30
Router1 (Inside Address) 10.0.0.1 /24
Switch N/A
PC1 10.0.0.50 /24