Programmer for Allen-Bradley SLC 5/03 and PanelView 650 needed

  • Posted:
  • Proposals: 6
  • Remote
  • #2588032
  • via mobile app
  • Open for Proposals
Alex N.Sebastian M.JinGe C.Ronald M.Kevin Z. + 1 other have already sent a proposal.
  • 9


Experience Level: Intermediate
My paper laminating machine has developed a fault and will not boot up.
It shows the following error on PanelView '613 Required Network node (s) not found'
The SLC 5/03 shows:
Power status indicator on; RS 232 is off; FLT status is off; DH-465 is on green
The Battery indicator was on and I have replaced it but with no change.
I am looking for someone who can investigate problem and repair or reprogram if needed.
I have wiring diagrams and operating manual but not the program.
I am based in Hampshire near Basingstoke.
Many thanks for looking at this. David Holloway
Many thanks

New Proposal

Create an account now and send a proposal now to get this project.

Sign up

Clarification Board Ask a Question

    There are no clarification messages.