Need logo turned into multi color, 3D print

I have a 4 color logo that I would like to print with my multi material printer. I would like to print it in a variety of sizes, which I will list below. For the largest print, I will need to the logo split up into 6 separate prints, as the total size exceeds the limit of my 3d printer.

The letters, farm house scene, and slogan, along with the circle surrounding the entire logo would be raised a bit from the back ground.

3D files needed:
1 - 23.5 inches wide, 19 inches high, .75 inch thick. I would like this print split up into 6 different tiles (in 4 color multi material) so it can be printed and glued together.

1 - scaled and optimized to be 8 inches high and a quarter inch thick (one print, 4 color)

1- scaled and optimized to be 3 inches high

1-scaled and optimized to be 2 inches high, with spaces for 6 10x4x2mm magnets to be inserted while print is paused. Thickness may need to be modified to accommodate the magnets. The slogan "life tasting better" might need to be dropped as it may be to small to print correctly.

Instead of using multi-material, I would also be open to varying the heights a bit, so that all letters a certain color would be a certain height, so we could just switch out the filament instead of using the multi material print.