2 d and 3d plan

I need a 2 d floor plan simple trestle table layout for an exhibition.
with 3 d version graphics version based on the same

The largest room is the Banqueting Hall GROUND FLOOR 37.9 m long 14.3m wide.

The second room is the PANDON room on the 1st floor which is directly above partially over hanging and looking over the balcony down to the Banqueting Hall.
At 13.64 x 14.94 the Pandon has a lower ceiling as detailed

Tables are

Preferred tables in order of use

183 cm long x 65 cm wide Rustic style (30 off)
220cm x 76cm wide Rustic Style (8 off)
To be used on Ground floor.

Additional Tables to add to Ground Floor Banqueting Hall and then the Pandon Room should use the tables below

153 cm long x 76 cm wide (plain Trestle Table) (30 off)

183 cm x 76 cm wide (plain Trestle Table) ( 20 off)

I need to maximise the number of tables in each room. with a gap of 50 cm between tables and to the rear of the tables which are on the perimeter wall of each room with an island of stands back to back in the centre in rectangle shape in the larger room and square in the Pandon unless you can see a better option, its important that we have a flow where visitors can walk around with pushchairs if necessary and that they are not looking directly at back of exhibitors stands

There should be no tables on the right hand side of the Pandon room where the Bar area is.

After that i need 3d visualisation of this it is new project it is similar to last plan table wise and room size.
I need the 2d within 48hours and the 3d within 96 hours please

I have photographs and video of the rooms which can be uploaded too.

Thanks

Peter