Arduino Sketch for Wemos D1 Mini based Controller

Software for a Primary Controller which has a 2.4" display and rotary encoder with switch. It also has a Temperature/Humidity monitor and a microwave presence sensor.
A menu system defines operating parameters. When operating parameters are satisfied, a switch ON time (seconds) and a switch OFF time are wirelessly sent to a remote relay which turns a device ON and OFF.
The parameters are such things as temperature, humidity, presence (of a person/animal greater than 40kgs) and Time Of Day, that activates a table of ON and OFF values. When these values are sent to the remote relay and stored, they are used until an updated set of ON and/or OFF values are sent from the main controller to the relay.
Budget for this project will be determined by discussions with freelancer, but we expect it to be above $USD 1000
Suggested Hardware:
Main Controller
Wemos D1 Mini
2.4" TFT Color LCD
KY-040 Rotary Encoder
TOD module
GY-BME280 3.3V Temp/Humidity sensor
DF Robot Microwave Presence Sensor
6000mAh battery

Relay to power device ON/OFF:
Wemos D1 Mini
Relay Shield for Wemos
This device is not battery powered, but gets power (5V) from the device

Communication between Master (main Controller) and Slave (Relay for device) is using ESP NOW.

Flowchart available.

This project is ongoing and will have future expansion requirements.