Gerber Step and Repeat

  • Posted:
  • Proposals: 1
  • Remote
  • #662978
  • Awarded
has already sent a proposal.
  • 1


Experience Level: Intermediate
I attach a zipped file of a panel I had designed some years ago.
I want now to just take the T28 board in the bottom right hand corner, and to make a step and repeated panel containing, say, 12 boards in a 4x3 pattern, with 2mm gaps and a 10mm all round border. This is much as you did at the end of our previous T102 job.
If this is not possible, can you just copy the T28 board on to a new Cadstar design, and then step and repeat.
All the best

New Proposal

Create an account now and send a proposal now to get this job.

Sign up

Clarification Board Ask a Question

    There are no clarification messages.