CAD design
4719
£20/hr(approx. $25/hr)
- Posted:
- Proposals: 3
- Remote
- #69470
- Archived
Description
Experience Level: Intermediate
CAD design of simple mechanical device to prep for "3D rapid prototyping"
I need a mechanical device - basically a Drum with 4 large holes drilled through it, with stub shafts on each end and mounted on needle bearings.
Optionally, 2 or more drums can be mated together, so one of the stub shafts/bearings on each drum would be replaced by a mating mechanism. The drum is 12" diameter and 7" thick.
The 4 holes.. actually channels... are 1"x2", drilled at 45 degrees to one another and they do not intersect in the center of the drum, they are slightly offset from one another so as to pass over each other.
I need a mechanical device - basically a Drum with 4 large holes drilled through it, with stub shafts on each end and mounted on needle bearings.
Optionally, 2 or more drums can be mated together, so one of the stub shafts/bearings on each drum would be replaced by a mating mechanism. The drum is 12" diameter and 7" thick.
The 4 holes.. actually channels... are 1"x2", drilled at 45 degrees to one another and they do not intersect in the center of the drum, they are slightly offset from one another so as to pass over each other.
Kyle K.
0% (0)Projects Completed
1
Freelancers worked with
1
Projects awarded
25%
Last project
20 May 2011
United States
New Proposal
Login to your account and send a proposal now to get this project.
Log inClarification Board Ask a Question
-
There are no clarification messages.
We collect cookies to enable the proper functioning and security of our website, and to enhance your experience. By clicking on 'Accept All Cookies', you consent to the use of these cookies. You can change your 'Cookies Settings' at any time. For more information, please read ourCookie Policy
Cookie Settings
Accept All Cookies